Isometric Style Configuration - Coordinates

The options in the Coordinates section let you specify where to place coordinate labels and/or use Elevation Labels instead of full coordinate labels. Once the settings have been defined, slick the Save button to apply them.

Note: To apply the settings to a previously generated isometric, the user will need to save the Style Configuration settings and regenerate the isometric(s).

Setting	Description
At Start Point	Each isometric has a start point and this point can be labeled. The purpose of this option is to be able to have exactly one coordinate label in the isometric when all the other options are unchecked. The coordinate label will display similar to the image below:
At Equipment	Outputs a coordinate label at the transition from NEW to equipment.
At Open End	Outputs a coordinate label at an open end. An open end is basically an unconnected node which the software interprets as open.
At Closed End	Outputs a coordinate label at a closed end. A closed end is basically an unconnected node which the software interprets as closed.
At Line/Line Transition	Outputs a coordinate label where a line transition occurs. The way this option operates is when OpenPlant Isometrics Manager sees a transition from NEW to CONTINUATION and none of the involved components include a nozzle, this option is used. Note: OpenPlant Isometrics Manager cannot determine if the transition is a line to line or sheet to sheet transition. So the option is used for both.
At New/Existing Transition	Outputs a coordinate label where a transition from NEW to EXISTING occurs.
Threshold for Open and Closed Ends	This is specific for OPEN/CLOSED ends. When the diameter of the open/closed end is smaller than the threshold value the coordinate label will be suppressed.
Output Coordinate Labels as Elevation	All the previous option output a full coordinate label. This option only outputs the elevation as shown below:
Suppress Elevation Labels	The full coordinate labels as set by the above options always output on ports. It may however be required that in selected intersection points (Tee, elbows, olets) an elevation coordinate is required. Typically OpenPlant Isometrics Manager outputs only the minimal required set.
Dual Coordinates Dimension	Displays dual dimension of coordinates inside Isometrics drawing (Metric and Imperial).